Absolute Pest Solution

Main uses

Conbextra GP2 is a blend of Portland cement, graded fillers and chemical additives which impart controlled expansion in the plastic state whilst minimising water demand. The low water demand ensures high early strength. The graded fi llers are designed to assist uniform mixing and produce a consistent grout.

Advantages

• Gaseous expansion system compensates for shrinkage and settlement in the plastic state
• No metallic iron content to cause staining Pre-packed material overcomes onsite batching variations
• Develops high early strength without the use of chlorides
• High ultimate strength ensure the durability of the hardened grout
• Free flow ensures high level of contact with load bearing area
• Conbextra GP2 is supplied as a ready to use dry powder. The addition of a controlled amount of clean water produces a free fl owing, non-shrink grout for gap thicknesses up to 100mm. Conbextra GP2 is a blend of Portland cement, graded fi llers and chemical additives which impart controlled expansion in the plastic state whilst minimising water demand. The low water demand ensures high early strength. The graded fi llers are designed to assist uniform mixing and produce a consistent grout. 

Conplast WL Xtra is a dark brown liquid based on cement dispersion polymers which mixes readily with water and therefore disperses evenly. Conplast WL Xtra waterproofs by improving the quality of the concrete or mortar. It reduces the water demand for required workability and minimises segregation and bleeding. Thus it is more effi cient compared to traditional powder and conventional integral waterproofi ng compounds as its use results in two fold improvement of concrete or mortar. 

Renderoc Plug is supplied as a ready to use blend of dry powders which requires only the addition of clean water at site to produce a highly consistent, rapid setting mortar which is easy to apply in many diffi cult conditions. The material is based on a blend of cements, graded aggregates, special fi llers and chemical additives which control the rate of set and minimise the risk of thermal cracking.